What are the components of the filter press produced by the filter press manufacturer?

Components of the Filter Press Produced by the Filter Press Manufacturer

The structure of the filter press produced by the filter press manufacturer consists of the following parts:

1. Rack

The frame is the basic component of the filter press, with thrust plates and pressure heads at both ends, and beams on both sides connecting the two. The beams are used to support the filter plates, filter plate frames, and pressure plates.

• Thrust Plate: Connected to the support, it places one end of the filter press on the foundation. The thrust plate of the chamber filter press has a supply hole in the middle and four holes in the four corners. The top two corner holes are the inlet of the cleaning liquid or the extruded gas, and the bottom two corner holes are the outlet (underflow structure or filter outlet).

• Pressing Plate: Used to tighten the filter plate filter, with rollers on both sides supporting the pressing plate, allowing it to roll on the track of the beam.

• Beam: A load-bearing component. It can be made of hard polyvinyl chloride, polypropylene, stainless steel coating, or a new anti-corrosion coating, depending on the environmental anti-corrosion requirements.

2. Manual Compression, Mechanical Compression, and Hydraulic Compression of Filter Presses Produced by Filter Press Manufacturers

• Manual Compression: A screw mechanical jack is used to push the plate and tighten the filter.

• Mechanical Compression: The pressure mechanism consists of a motor (with overload protector configuration), reducer, gear payment, screws, and fastening nuts. When pressing down, the motor rotates, driving the reducer and gears to make the screws rotate in the fixed silk wool, pushing the plate to press the filter plate and filter. If the pressure becomes larger, the motor load current increases. If it exceeds the current value set by the protector, the motor cuts off the power supply and stops rotating. The screws and fixed screw nuts have a reliable self-locking spiral angle, ensuring the stable compression state during operation. When returning, the motor reverses, and the pressure block of the pressure plate presses in contact.

• Hydraulic Compression: The hydraulic compression mechanism consists of a hydraulic station, oil barrel, piston, piston rod, and a structure of a Havranka hydraulic station connected to a pressure plate. It includes a motor, oil pump, overflow valve (pressure regulating), directional valve, pressure gauge, euro, and oil tank. When the hydraulic compression pressure is mechanically pressed down, the hydraulic station supplies high-pressure oil, and the component cavity composed of the cylinder and the piston is filled with oil.