How is diaphragm filter press widely used in production and processing

The common characteristics of  membrane filter press industrial production applications are fine particle size distribution,slow foundation settlement,low slurry viscosity,and poor filterability.Therefore,the automatic membrane filter press requires a large separation area and relative filtration working pressure.Traditional solid-liquid separation equipment can no longer be considered to dry regulations.Today,the machine for filtering fine sand materials is a fully automatic membrane filter press.

Adjust all automatic diaphragm filter presses to work and check all equipment before each trip.The mechanical equipment of the automatic diaphragm filter press reduces the transmission system components,and the reduction box must be filled with grease;the hydraulic press is used to check the working capacity of the oil tank and the pressure of the hydraulic system.

Gear oil is generally replaced once a year,and the hydraulic press of the automatic diaphragm filter press needs to be replaced.This system software is used for cleaning.The hydraulic system pressure is lower than the cylinder pressure,but the value cannot be lower than the agreed value of the working pressure.If it is too small,it will cause many leaks and damage the equipment.

In the original working pressure filtration link,the turbidity of the automatic membrane filter press is higher.When anaerobic granular sludge is produced on the automatic membrane filter press,the leachate will become clearer and clearer.If the leachate is turbid or clear and mixed,it means that the filter cloth of the automatic membrane filter press is damaged or the cloth holes are displaced from the welding bolts.At this time,the gate valve should be closed or the feeding should be stopped,and the filter cloth of the filter press should be replaced.There is a small amount of leakage caused by the diffusion phenomenon of the filter cloth of the filter press,which is agreed in the middle of the automatic membrane filter press.

The mortar that is difficult to produce and process in the entire production process is reduced to relatively dry soil through the automatic diaphragm filter press,and the production and application are immediately circulated.The automatic diaphragm filter press greatly reduces the labor of the actual operator,reduces the waste of manpower and the economic development cost of the actual operation of the automatic diaphragm filter press.

1.The automatic diaphragm filter press is installed on flat concrete.This is especially easy to be overlooked by customers.Many customers can find the direction of the equipment at will without paying attention to pre-embedding enough indoor space for future application.It may take a lot of work to apply it,so I hope you pay attention to this.

2.The presser foot of the box filter is fixed with anchor bolts,and the foot of the thrust plate is fixed at the feed end.After positioning the fixing screws,lock them with 2 nuts.The equipment personnel must ensure that the crossbeam and thrust plate remain stationary.

Reasons for the slow operation of  diaphragm filter press:

Hydraulic transmission system fatigue

The hydraulic system provides a strong driving force for the whole operation of the equipment,including the extrusion of the membrane filter press,pulling back the promotion plate,pushing the pull plate car to operate,etc.All of these are completed by the hydraulic system of the equipment to increase a strong driving force.

Therefore,during the use of the membrane filter press,the hydraulic system of the equipment is used most frequently and has the greatest strength.Of course,it is the component that is most prone to fatigue in the equipment.